Citroën AK400 Van

The diary of the restoration
of SEE 881T

7th October 2001

Repaired front cross beam

Click on thumbnail to see big photo.

Even though the body is on its side I have show these photos the "right" way up.

The cross beam, which is at the rear of the passenger compartment floor, was rusty. 1_small.jpg (1514 bytes)
As I had a spot welder I decided to take out the full width of the underside panel and spot-weld in a new one. 2.jpg (6721 bytes)
As some of the front surface had also rusted I cut that away and made an angled sheet to weld on top. 3.jpg (6648 bytes)
I managed to spot-weld the front sheet on even though there is a reinforcing plate behind it. It was then easy to spot-weld the bottom plate onto the flanges. 4.jpg (8525 bytes)

Previous Next

Home